The right way to Build a Shelf Utilizing Brackets

Brackets are available in a myriad of shapes and sizes. Using brackets to help and create a shelf allows the shelf to be coordinated with the room decor, be customized-sized, and be built by an intermediately expert dwelling decor DIY-er. Several cabinets, staggered on a wall, make a severe design statement. A shelf positioned above a door is a discovered-space storage solution, and a collection of cabinets running around a room’s perimeter, high on a wall, can make a lateral book case for a small library.

Step 1

Select brackets that may accommodate the chosen shelf. A typical shelf is 12 inches deep. This is the measurement from the front of the shelf to the wall. Brackets are basically “L” -shaped; one leg of the L is hooked up to the wall, the opposite leg, which protrudes from the wall at a 90-degree angle, helps the shelf. The size of the protruding leg have to be at the very least -thirds of the depth of the shelf. For example, if the desired shelf is 12 inches deep, the supporting legs of the bracket must be a minimum of 8 inches. Normally, both legs of the brackets are the same length; however this is not a hard rule.

Step 2

Choose the number of brackets to make use of for the shelf. If the brackets are spaced too far aside, the shelf will sag. A very good rule of thumb is to place a bracket every sixteen inches. Place one at every finish of the shelf, 1 inch from the outside edge, and each sixteen inches along the shelf length.

Step three

Mark the wall, with the self-erasing marker, at the place of the beneathside of the shelf. Measure the distance from the ground to this mark. The ninety-degree angle of the bracket will be aligned with this mark. The shelf will sit on the legs of the brackets that protrude from the wall at this mark. Mark the wall, measuring up from the floor, at sixteen-inch increments, one location marker for each bracket and one mark for every of the top brackets.

Step 4

Install the brackets onto the wall on the indicated bracket locations, following the manufacturer’s directions for attaching the brackets to the wall.

Step 5

Place the shelf, centered, on prime of the brackets and insert screws up by the brackets into the bottom of the shelf to secure it into position. It is helpful to pre-drill the screw holes to forestall a wood shelf from splitting.

In case you loved this short article and you wish to receive much more information relating to Fireplace Mantel Brackets please visit our own webpage.